Part / Drawing Request
✕
More info: 230 Micro Pump™ product page
Troubleshooting
Articles
The Uni-Max® pump is cycling, but the output is inconsistent.
230 Micro Pump™ is not stroking.
Low-level switch does not change state.
No fluid coming out of 230 Micro Pump™.
Pulse R Fault Codes.
Solenoid valve stuck open or closed.
There is fluid in the outer coax tubing.
Fluid is dripping from nozzles
Smoking tools
Too much mist/fog in the air.
more
Installation / Setup
Articles
Uni-Max Pro Flow Sensor Calibration Procedure
Uni-Max Pro Flow Sensor Operation
Uni-Max ST & Pro - Understanding Output Mode (Continuous vs Shot)
Coaxial Tubing Installation Guide.
How to install the Bat or BSB & BSG nozzles.
How to wire the Pulse R with flying leads and Air Solenoid together.
How to trim coaxial tubing.
How to retrofit an existing nozzle to fit the 230 Micro Pump™ QD Splicer.
How to connect a nozzle to the 230 Micro Pump™ system.
How to prime the 230 Micro Pump™ system.
What is the voltage requirement for the Pulse R?
How to install a Pulse R onto an existing system.
How to wire my solenoid valve.
How to shorten a coaxial output line.
Can I run lubricated air to the system?
Where to connect air to a Coolubricator, Serv-O-Spray, or Saw Blade Lube system?
Videos
▶
Nozzle Positioning For Milling
System Maintenance
Articles
Videos
▶
230 Micro Pump - Adjustable Output Rebuild
▶
230 Micro Pump - Fixed Output Rebuild
▶
Replacing Coaxial Nozzles & Splicer Pins
General
Articles
How to Find Your Unist System Serial Number
Coaxial Tubing Service Life.
What is the brass knob on my MQL system?
When do I use coiled versus straight tubing on a Single Line system?
How to adjust the 230 Micro Pump™ output.
How to prevent someone from turning the 230 Micro Pump™ adjustment knob.
What does the "P" mean on the 230 Micro Pump adjustment knob?
How to replace a 230 Micro Pump™.
What the numbers on a 230 Micro Pump™ mean?
How to change modes on a Pulse R.
Timing with multiple Pulse R's at the same rate.
Pulse R Display Units.
When to use 1 versus 2 spray nozzles.
What fluids and components should be kept out of Unist systems?
What is the mesh screen size on a 16, 32, or 64 oz fluid reservoir?
What are my options for reservoirs larger than 64 oz?
How short can a nozzle be made?
Why is there a hole in the splicer pin?
Videos
▶
Flexible Plastic Nozzle Tip Product Improvement
▶
Capillary Splicer Product Improvement
Not finding what you need?