Part / Drawing Request
✕
Troubleshooting
Articles
Air bubbles in the fluid line
Pulse R Fault Codes.
Solenoid valve stuck open or closed.
Low-level switch does not change state.
Pumps are not stroking.
Pump stack is leaking.
Pulse generator making a high-pitched noise and/or does not adjust.
There is fluid in the outer coax tubing.
Drain plug on pump is stripped out.
Fluid is dripping from nozzles
Smoking tools
Too much mist/fog in the air.
No fluid coming from pump.
Air, but no fluid out of nozzle.
Air bubbling up in reservoir.
more
Installation / Setup
Articles
How to wire the Pulse R with flying leads and Air Solenoid together.
How to change an actuation valve on a Coolubricator™ or Serv-O-Spray™ system.
How to install a Pulse R onto an existing system.
How do I prime my Coolubricator™ and Serv-O-Spray™ pumps?
How do I set up and maintain my air trap?
How do I wire my solenoid valve?
What should my initial system setting be?
How do I set up my Coolubricator™ or Serv-O-Spray system?
How do I shorten a coaxial output line?
Can I run lubricated air to the system?
Where to connect air to a Coolubricator, Serv-O-Spray, or Saw Blade Lube system?
How to prevent air metering screw from moving or backing out?
Videos
▶

How to Install Pulse R
▶

How to Replace Your Pulse Generator
▶

Nozzle Positioning For Milling
▶

Priming A Pump-Based MQL System
▶

How To Set Up Your Coolubricator™
System Maintenance
Articles
Videos
▶

Replacing Coaxial Nozzles & Splicer Pins
▶

Rebuilding MV Pumps
▶

Installing A Pump Rebuild Kit
General
Articles
What is the difference between a Coolubricator™ and Serv-O-Spray™ system?
When do I use coiled versus straight tubing on a Single Line system?
Can a spray system have both Coolubricator and Serv-O-Spray style outputs?
How to change modes on a Pulse R.
Timing with multiple Pulse R's at the same rate.
Pulse R Display Units.
When to use 1 versus 2 spray nozzles.
What fluids and components should be kept out of Unist systems?
What is the mesh screen size on a 16, 32, or 64 oz fluid reservoir?
How much air does my system use?
What are my options for reservoirs larger than 64 oz?
How short can a nozzle be made?
Why is there a hole in the splicer pin?
Videos
▶

Flexible Plastic Nozzle Tip Product Improvement
▶

Working With The Redesigned Capillary Splicer
▶

Capillary Splicer Product Improvement
▶

Tips & Tricks Of Working With Coaxial Tubing
▶

How To Disconnect & Connect Coaxial Hose
Not finding what you need?